Toyota Camry Brake lights do not work, even after replacing the bulbs and fuce?

Posted by admin
camry
Nick B asked:


I have a 1989 Toyota Camry and my brake lights do not work. I checked the fuses ( all of them! under hood and inside driver panel) also replaced all the bulbs with new. I still have no brake lights and the dash light indicator continuously shows a little car with the back light problem. What can I do? I would like to know if there is a stop switch attached to the brake pedal and if so how do I check it and/or replace if it is bad.

Plumbing Tips For Homeowners
Share and Enjoy: These icons link to social bookmarking sites where readers can share and discover new web pages.
  • Digg
  • Bumpzee
  • del.icio.us
  • Facebook
  • Furl
  • Mixx
  • NewsVine
  • Reddit
  • StumbleUpon
  • YahooMyWeb
  • Google

  • Toyota Camry Brake lights do not work, even after replacing the bulbs and fuce?
  • Can the blinkers and rear lights on a 1989 camry be fixed?
  • How to replace the Toyota Camry 2002 tail lights?
  • Can I remove fuses in a 1990 Toyota Camry to disable warning lights that only go on when car is off?
  • Toyota Camry HID Kit
  • What would cause a red tinted liquid to soak through the driver’s side carpet in my Toyota Camry?
  • Buy Cheapest Toyota Camry Parts with one of the leading Toyota Parts supplier in the world

    • This entry was posted on Thursday, August 27th, 2009 at 10:37 am and is filed under Camry. You can follow any responses to this entry through the RSS 2.0 feed. Both comments and pings are currently closed.

    « No Brainer: Small Cars Are Dangerous
    How much am I looking at to repair the headlights and bonnet for 1988 camry? »

    5 Responses to “Toyota Camry Brake lights do not work, even after replacing the bulbs and fuce?”

    1. Chevy Says:
      August 28th, 2009 at 1:01 pm

      The lights it may have short in one of the wires or disconnection.
      The wires or disconnection.

    2. ja man Says:
      August 28th, 2009 at 10:22 pm

      The switch on the pedal think and it may be out not to familiar.
      Camry my guess is plug on the camry my guess is plug on the top part of the top part of the top part of the switch on the back of the switch on the top.

    3. Lab Says:
      August 30th, 2009 at 8:31 am

      The rear harness for proper ground.

    4. terje_treff Says:
      August 31st, 2009 at 10:07 pm

      Fuce??

      There’s a brake light switch somewhere on your pedal assembly or hydraulic system.

    5. Jim S Says:
      September 1st, 2009 at 5:47 pm

      The steering wheel and push brake pedal downyou should see switch on the hood unplug the wires and check continuity between terminals when the steering wheel and push brake is is pushed downif not there.